Due to Covid-19 virus there are fewer airplanes flying International routes. Thus, there is a HUGE delay on International orders shipped by USPS.
Currently there are no delays on International orders shipped by FedEx, UPS or DHL and you can select collect freight when placing your order.

Ultrasonic Generator 200W - Adjustable 80-132 KHZ ASIC

SMUG200W80132ND - 1 Pc/Set
Manufacturer part number: SMUG200W80132ND
Availability: Out of stock
/1 Pc Set
Condition: New

Part Number: SMUG200W80132ND

Ultrasonic generator for Bolt Clamped Langevin Transducers with frequency from 80 to 132KHz +/-3khz. Frequency is simply adjusted.
This ultrasonic generator uses new application-specific integrated circuit (ASIC) which results on a very concise line with high reliability.
Generator is shipped with frequency set to 80KHz. If using a different frequency it must be adjusted prior of using the generator.

Power Output : 200 W  
Power Input Voltage : 110V AC
Frequency range: 80KHz to 132KHz ±3KHz (shipped set to 80 KHz)
Dimensions: 180 X 130mm   
Test Condition: 23±3 °C 40~70% R.H.
Cs => LCR meter at 1KHz 1Vrms

Connect the supplied 15V AC transformer to the plug shown on the drawing below. Generator cannot be turned ON without the 15V AC transformer connected to it.
Connect the generator to 110V AC using connectors L and N. Turn it ON without the transducers connected to it.
Use a frequency meter and connect its probes, minding the polarity (+/-), to the 12V DC contacts shown on the lower right corner of the drawing. Using its mini screws, tune the two blue pods until you have set the desired frequency. Now the generator should be turned OFF so the transducer can be connected to it.
For each different transducer frequency this process should be repeated so the generator’s frequency matches the transducer’s frequency.

Please read the specs of the product on this link: SMACCLED01 to know how the power is adjusted.

The Positive electrode on the transducer is the one between the two piezo ceramic rings. All transducers should be connected in parallel using the correct polarity. Positive and Negative wires coming from the transducer will connect to the Positive and Negative output connectors on the generator shown at the top left on the above drawing.

1-- This generator set includes a LED DISPLAY PANEL that allows to have the power manually adjusted. It will also add a timer function to set a running time after which the generator will turn OFF.
The LED display panel has two buttons for adjusting the power and two others for adjusting running time. It also has an ON/OFF button. Each of the 10 LED bars represents 10% of the total generator power.
2-- If your assembly design needs, we can also supply (not included on the generator's price) a cooling fan that you can see on this link  ==> SMCF120A26K

=> GENERATOR MUST HAVE A COOLING FAN BLOWING AIR ON ITS HEAT SINKS AND ELECTRONICS. We suggest two fans for protection redundancy. </strong

Specification of products can change without notice.

Additional Notes:
Product tags